Bosch D-tect200C, Operating/Safety Instructions Manual

-10-

Section 15.525 Coordination requirements.

(a) UWB imaging systems require coordination
through the FCC before the equipment may be
used. The operator shall comply with any
constraints on equipment usage resulting from
this coordination. 

(b) The users of UWB imaging devices shall supply
operational areas to the FCC Office of Engineering
and Technology, which shall coordinate this
information with the Federal Government through
the National Telecommunications and Information
Administration. The information provided by the
UWB operator shall include the name, address and
other pertinent contact information of the user,
the desired geographical area(s) of operation, and
the FCC ID number and other nomenclature of the
UWB device. If the imaging device is intended to
be used for mobile applications, the geographical
area(s) of operation may be the state(s) or
county(ies) in which the equipment will be
operated. The operator of an imaging system used
for fixed operation shall supply a specific
geographical location or the address at which the
equipment will be operated. This material shall be
submitted to the following address:

Federal Communications Commission
Frequency Coordination Branch, OET,
ATTN: UWB Coordination
Washington, DC 20554 

(c) The manufacturers, or their authorized sales
agents, must inform purchasers and users of their
systems of the requirement to undertake detailed
coordination of operational areas with the FCC
prior to the equipment being operated. 

(d) Users of authorized, coordinated UWB
systems may transfer them to other qualified
users and to different locations upon
coordination of change of ownership or location
to the FCC and coordination with existing

authorized operations. 

(e) The FCC/NTIA coordination report shall
identify those geographical areas within which
the operation of an imaging system requires
additional coordination or within which the
operation of an imaging system is prohibited. If
additional coordination is required for operation
within specific geographical areas, a local
coordination contact will be provided. Except for
operation within these designated areas, once
the information requested on the UWB imaging
system is submitted to the FCC no additional
coordination with the FCC is required provided
the reported areas of operation do not change. If
the area of operation changes, updated
information shall be submitted to the FCC
following the procedure in paragraph (b) of this
section. 

(f) The coordination of routine UWB operations
shall not take longer than 15 business days from
the receipt of the coordination request by NTIA.
Special temporary operations may be handled
with an expedited turn-around time when
circumstances warrant. The operation of UWB
systems in emergency situations involving the
safety of life or property may occur without
coordination provided a notification procedure,
similar to that contained in Section 2.405(a)
through (e) of this chapter, is followed by the
UWB equipment user. 

For Canadian Customers only 

This In-wall Radar Imaging Device shall be
operated where the device is directed at the wall
and in contact with or within 20 cm of the wall
surface. This In-wall Radar Imaging Device shall
be operated only by law enforcement agencies,
scientific research institutes, commercial mining
companies, construction companies, and
emergency rescue or firefighting organizations. 

This device contains licence-exempt
transmitter(s)/ receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference,

including interference that may cause
undesired operation of the device.

This In-wall Radar Imaging Device shall be
operated where the device is directed at the wall
and in contact with or within 20 cm of the wall
surface. 

This In-wall Radar Imaging Device shall be
operated only by law enforcement agencies,
scientific research institutes, commercial mining
companies, construction companies, and
emergency rescue or firefighting organizations.

ISED Canada

FCC Statement

Dtect200C_2610067510_01-22.qxp_D-tect200  1/18/22  1:43 PM  Page 10