Part IV: Multi-Area Use
MOVE TO AREA ? (C 5 + 0)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
MOVE TO AREA ? (C 5 + 0)
With this function you can perform tasks in an area other than the one you’re in without having to physically go to that
area. Your access to other areas is limited by the scope of the command center and your authority level. For example, if
your passcode gives you authority to all 8 areas, but the command center you’re working with is limited in scope to areas
1 and 2, then you will only be able to move to either area 1 or area 2.
Upon moving to another area, the range of tasks you may perform depends upon the command center you’re working
with. Once you’ve performed a task (such as
Turning the Area On
), the command center reverts back to its programmed
area after 10 seconds. Thus only one task can be performed in another area at a time.
1.
Ensure your command center shows idle disarmed
text.
2.
Press the
COMMAND
key. Press the Menu> key to
enter the Command Menu,
3.
The display shows *
SYSTEM COMMAND*
.
4.
Press the
5
key and then the
0
key.
+
Note:
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key
then press Next> repeatedly
until you reach the MOVE TO AREA ?
>
prompt then press the
adjacent soft key.
5.
You may be prompted for your passcode. If so, enter
your passcode and press the
ENTER
key. It will appear
on the display as asterisks (*).
The
<Exit
soft key will quit this function and return to
idle text.
6.
The command center will then display the Area Name Text of each area that falls within the scope of
the command center and authority level of the user, if applicable. (All 8 area names are shown as an
example).
Note:
If the user's authority level does not permit access to a certain area and that area is not
within the scope of the command center, or the area is not enabled, it will not appear in the
display.
If the area you wish to move to does not appear in this list, press the Next> key to display additional
areas.
To select an area, simply press the soft key corresponding to the Area Name
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
