Part II: System Commands
MASTER ARM ? (C 1)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
MASTER ARM ? (C 1)
Description
Use this function to turn on the entire system, both perimeter and interior. When you turn on the system, the display
shows how many seconds of exit delay time you have to exit the protected area. You should leave before exit delay time
expires.
Leaving after exit delay has expired will cause the entry delay to start. You may also cause an alarm on an interior device.
Enter your personal passcode to disarm the system.
This function may be used by your cleaning service, a serviceman, or others who need to turn on your system when they
leave.
Using Master Arm:
Note:
Using the C1 shortcut will only arm the area where the keypad has been assigned. Example, if the
D1260 is assigned to Area 1, only Area 1 will be armed when C 1 is pressed.
1.
The display shows disarmed idle text.
2.
Press the
COMMAND
key.
3.
The display shows
*System Command*
.
4.
Press the
1
key.
5.
If your system is programmed to require a passcode
when performing a COMMAND 1, the display
prompts you to enter your passcode.
The passcode is shown as asterisks (*).
6.
If the passcode has valid authority for this command,
the display shows
Exit now #
(# = exit delay time
remaining)
seconds remaining
.
After the exit delay time expires, the display changes to
idle armed text.
7.
To disarm your security system, enter your personal
passcode and press
ENTER
.
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
