Part II: System Commands
VIEW MEMORY ? (C 4 + 0)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
VIEW MEMORY ? (C 4 + 0)
View Event Memory
Description
Your system stores events that occurred since the last time memory was cleared. Use COMMAND 40 to view Event
Memory.
Event Memory allows you or a service technician to review events after they are cleared from the command center’s
display. *
ALARM SILENCED*
will continue to scroll to remind you that events are stored in Event Memory.
Each time you turn on the system on, the Event Memory is erased and the
ALARM SILENCED
message is cleared.
Using View Memory
:
1.
Ensure your command center shows idle disarmed
text.
2.
Press the
COMMAND
key.
The display shows
*System Command*
.
3.
Press the
4
key, followed by the
0
key.
+
Note:
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the MENU> soft key to enter the Command Menu,
then press NEXT> soft key repeatedly
until you reach the
VIEW MEMORY ?>
prompt, then press its
adjacent soft key.
Press ENTER.
4.
Your system displays event summary lines and point text in this order:
A.
fire alarm summary line,
B.
point text for each fire alarm event;
C.
alarm summary line,
D.
point text for each alarm event;
E.
fire trouble summary line,
F.
point text for each fire trouble event;
G.
trouble summary line, and
H.
point text for each trouble event.
5.
Press
NEXT>
to scroll through the events.
If there are no events to view,
There are currently no
events in memory
displays.
6.
You can return to idle text at any time by pressing
Exit>
soft key.
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
