Part II: System Commands
RESET SENSORS ? (C 4 + 7)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
RESET SENSORS ? (C 4 + 7)
Reset Sensors
Description
Detection devices, such as smoke detectors and shock sensors, must be reset after being activated. This function
momentarily removes power from these sensors to reset them.
It also clears point information from the display, leaving the *
ALARM
SILENCED
*
message in the display as a reminder that the View Memory
function can be used to view the cleared point information.
To clear the event memory and remove the *
Alarm Silenced*
message
from the display, press the
Clear Display>
soft key.
The display will show the instructions for clearing the message. Enter a
valid passcode and press the
Clear>
soft key.
Arming the system will also clear the display and the event memory.
Using Reset Sensors
:
1.
Ensure your command center shows idle disarmed
text.
2.
Press the
COMMAND
key.
3.
The display shows
*System Command*
.
4.
Press the
4
key, followed by the
7
key.
+
Note:
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the RESET SENSORS ?
>
prompt then press the
adjacent soft key.
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
