Part III: Advanced Commands
BYPASS A POINT? (C 0)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
BYPASS A POINT? (C 0)
Description
This command allows you to bypass points that you do not want included in the system. Points that are not included in
the system do not detect intruders and cannot send any reports. You can bypass points when an area is disarmed.
Bypassing a point reduces the level of security and should be used with discretion. Points remain bypassed until you
unbypass them or some points may return when the area is disarmed. See
Unbypassing a Point
(COMMAND 00).
You could use
COMMAND 0
to leave a window open over night without initiating an alarm. Also see
Turning the System
On With Doors or Windows Open
.
Using Bypass a Point
1.
Ensure your command center shows idle disarmed
text.
2.
Press the
COMMAND
key.
3.
The display shows
*System Command*
.
4.
Press the
0
key.
Note:
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the BYPASS A POINT ?
>
prompt then press the
adjacent soft key.
5.
You will prompted for your passcode. It will appear on
the display as asterisks (*).
6.
The display changes to show
Enter point number or
press next key
.
7.
If a digit is pressed, the display shows
Enter point
number: #
. As soon as a digit key is pressed, the display
changes to
Entering point number:
.
(# is the point number entered)
If you know the point number you wish to bypass,
enter the number and press the
Enter>
soft key
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
