Part III: Advanced Commands
UNBYPASS A POINT? (C 0 + 0)
D1260 Owner’s Manual
© 2003 Bosch Security Systems
50410C
UNBYPASS A POINT?
(
C 0 + 0)
Description
Unbypassing a point is a way to return a bypassed point to the security system so that it can once again respond to
trouble and alarm conditions.
Using Unbypass a Point:
1.
Ensure your command center shows idle disarmed
text.
2.
Press the
COMMAND
key.
3.
The display shows
*System Command*
.
4.
Press the
0
key twice.
+
Note:
If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the UNBYPAS A POINT ?
>
prompt then press
the adjacent soft key.
5.
You will prompted for your passcode. It will appear on
the display as asterisks (*).
6.
The display changes to show
Enter point number or
press next key
.
7.
If digits are pressed, the display shows
Enter point
number: #.
As soon as a digit key is pressed, the display
changes to
Entering point number:
.
(# is the point number that was entered)
If you know the point number you wish to unbypass,
enter the number and press the
Enter>
soft key
or the
ENTER
button.
Summary of Contents for D1260 Series
Page 2: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 4: ...Contents D1260 Owner s Manual 50410C 2003 Bosch Security Systems ...
Page 144: ...Appendix Passcode Worksheet D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
Page 154: ...D1260 Owner s Manual 50410C 2003 Bosch Security Systems Notes ...
