D9131A
Event Description and Troubleshooting
D9131A User's Guide
© 2002 Bosch Security Systems
Page 7
34584G
Event
Description
Enter
Request To Exit
A Request To Exit device for an access door has been activated.
Restoral Report
Restoral at point in area specified.
RF Low Battery
A Low Battery condition at the point specified has been detected.
RF Batt Restor
The Low Battery condition previously sent from the point specified has restored.
RTE Deny
Intrlok
A Request To Enter device has been activated but was denied due to the interlock door
being open.
RTE Deny
Secured
A Request To Enter device has been activated but was denied due to the door being
Secured. See Door Secured.
REX Deny
Intrlok
A Request To Exit device has been activated but was denied due to the interlock door being
open.
REX Deny
Secured
A Request To Exit device has been activated but was denied due to the door being Secured.
See Door Secured.
S: Alarm
Status report: alarm at area specified.
S: Closing
Status report: closing at area specified.
S: Fire
Supervision
Status report: Fire Supervision at area specified.
S: Opening
Status report: opening at area specified.
S: Perim Delay
Status report: area perimeter specified is armed with entry/exit delay.
S: Perim
Instant
Status report: area perimeter specified is armed (no delay).
S: Supervision
Status report: Supervision at area specified.
S: Trouble
Status report: trouble at area specified.
SDI Failure
Serial Device Interface specified is not reporting. 1-8 = command centers; 017, 018, 019 =
printers; 33-40 = Access Control Module. 80 = Home Automation;
88 = RAMIV/Netcom. Make sure the device is plugged in.
SDI Restoral
The problem with the device specified is resolved.
Sensor Reset
User with reported ID reset detection devices in area specified.
Service End
A Service Walk Test in the specified area has ended.
Service Start
A Service Walk Test in the specified area has started.
Sked Bypass
Sked* in area specified is bypassed.* System will not respond to faults at this device.
Sked Changed
User with reported ID changed the Sked* indicated.
Sked Executed
Sked* was activated.
Status report
Status report was sent to the receiver.
Supervision
Supervision condition at point specified.
Swinger Bypass
Area specified had four alarm or trouble signals within an hour. It is now bypassed from the
system.
Test Report
Test report was sent.
Time Changed
User with reported ID changed the time in the security system.
