Bosch Security Systems | 2007-11 | 9922 141 70691 en
DCN Wireless
| Installation and User Instructions | Central Devices
en
| 61
12
System configuration
12.1 Introduction
The central control unit controls the system. Use the
configuration menu of the central control unit to
configure the system.
12.2 Initialization
12.2.1 Introduction
Each active DCN device in the system must have an
address. The central control unit cannot send data to an
active DCN device that does not have an address.
During the initialization, the central control unit gives
addresses to the active DCN devices.
Each wireless device in the system must have a
subscription. The central control unit cannot send data
to a wireless device that does not have a subscription.
During the initialization, the wireless access point gives
subscriptions to the wireless devices.
12.2.2 System
You must do the initialization of the system before you
can use the system:
1 Select the
4L De-initialize
menu item of the
configuration menu of the central control unit.
2 Set the value of the parameter in the menu item to
Wired
. The addresses of all active devices in the
DCN are erased. All LEDs on all active devices in
the DCN come on.
3 Set the value of the parameter in the menu item to
Wireless
. The LED around the microphone button
of the wireless discussion units comes on as yellow
for 2 s.
4 Select the
4A Wireless Mode
menu item of the
configuration menu of the central control unit.
5 Set the value of the parameter in the menu item to
Subscription
.
6 Push the microphone button of each active device in
the DCN. When the central control unit gives an
address to an active DCN device, the LEDs of the
active device go off.
Note
It is not necessary to do an initialization when
the system is re-installed in another location and
contains the same devices after it is re-installed.
Active DCN devices hold their addresses.
Wireless devices hold their subscriptions.
Note
In the next step, you erase the subscriptions
from the wireless devices and the subscription
list from the wireless access point.
Note
Do not push more than one microphone button
at the same time. The central control unit cannot
give addresses to more than one active device
at the same time.
