17 | Recording and Telemetry
136 / 188
DDU 10
Bosch Motorsport
– To insure proper communication between WDServer and the receiver, do not delete
any old *.ini files from this folder path. As mentioned in section 5, RaceCon will gener-
ate a new *.ini file each time a project is synchronized; each new *.ini file instance has
an incremented file name. Retaining all of these *.ini file iterations will insure that WD-
Server always has a reference to whichever configuration is programmed into your
vehicle’s logger system.
– If the RaceCon project for the vehicle resides on a different computer, than that which
is used for telemetry, then all *.ini files for a given project should be transferred to the
telemetry computer after every data synchronization in RaceCon. WDServer may have
trouble recognizing *.ini files stored on removable media, so best practice is to copy
these files to the telemetry computer’s hard drive.
17.4.4 Loading the telemetry data
The following is an example of a file name and data format for Car #91. File is typically
located in WinDarab/Config/WDServer:
In the File Explorer, click ‘Open’ and navigate to the data set. Under ‘Network’, search for
the car or cars that are required for viewing.
17.5 Setup for USB recording
This function requires the installation of Software Upgrades. Look into the datasheet of
your device, to see which upgrades are available for your device.
Software Upgrade USB_DATA enables USB recording. To activate Software Upgrade
USB_DATA, enter the license key as described in the chapter ‘Feature activation’ [
}
19].
For USB recording, Software Upgrade FULL_LOG_1 should also be enabled.
Wiring harness
Bit
Value
USB_Device_Power
Power (red)
USB_Device_DP
D+ (green)
USB_Device_DN
D- (white)
USB_Device_Gnd
GND (black)
For further information, see the pinlayout of the device.
