Display Unit DDU 7
Error Memory | en
109
Bosch Motorsport
Manual
04.02.2019 | V 02 |
–
0 (FALSE) Error is inactive: error was not detected in most recent diagnostic run,
however the error has not been cleared from the memory by the user and remains in
the non
‐
volatile memory
The aforementioned channels (error_active_rotate, error_location_rotate, error_type_rotate)
are device specific properties (e.g. C 60) and are not related to the complete RaceCon project
(e.g. “error no. 3 from the error memory”). Therefore, only one property label is available in
each device. The errors from the error memory (possibly more than one error possible per
device) share these three labels. The labels cycle through the errors currently present in the
memory and represent the respective property of each error periodically.
The following screenshot shows error properties, which can be displayed or logged:
Labels hold information
on error 1 (an ANA3 error)
Labels hold information
on error 2 ... n-1
Labels hold information
on error n (a CAN error)
After the last error and its error properties have been displayed, the labels will start again with
the first error in the error memory stack and its error properties will be displayed again.
Therefore, monitoring these labels over a sufficiently long period provides the information on
all individual errors in the error memory.
To understand this behavior, it is recommended to observe the three labels in a measurement
sheet (while more than one error is active) and watch the values change periodically:
The verbal representation of the numerical codes of these labels can be visualized in the
properties window of the measurement page:
Summary of Contents for DDU 7
Page 1: ...Display Unit DDU 7 Manual V 02 2 4 2019 ...
Page 2: ......
Page 139: ...Display Unit DDU 7 Firmware en 139 Bosch Motorsport Manual 04 02 2019 V 02 ...
Page 155: ......
