Inputs and Outputs
Input channels
Analog inputs
The DDU 8 analog inputs accept an input signal of 0 to 5 V. A 3.01 kOhm pull‐up
resistor can be activated by software.
Digital inputs
The digital inputs of the DDU 8 accept 0 V to 5 V signals of Hall‐effect sensors by
default. Connect the output of the Hall‐effect sensor to the REVn.
Output channels
Sensor power supply
The DDU 8 has two types of sensor power supply: 5 V and 10 V regulated volt‐
age. The regulated 5 V and 10 V outputs can deliver 350 mA each. They are short
circuit protected to battery voltage and GND.
Communication channels
CAN bus
The DDU 8 has two CAN buses configurable as input and output. Different baud
rates are selectable. Please note that the DDU 8 does not contain any CAN termi‐
nation resistors. Thus the CAN termination resistors need to be integrated into
the wiring loom.
Ethernet channels
The DDU 8 has two 100 MBit full duplex Ethernet communication port. The port
is internally connected with an Ethernet switch. The Ethernet port has 'cable auto
crossover' functionality.
RS232 ports
The DDU 8 has one RS232 serial port. Baud rate for the port is programmable.
RS232 port is reserved for GPS receiver.
5
5.1
5.1.1
5.1.2
5.2
5.2.1
5.3
5.3.1
5.3.2
5.3.3
Inputs and Outputs | 5
Bosch Motorsport
DDU S2 PLUS Manual
11 / 136