en
Installation
14
Sliding out the appliance
Note:
Before you remove the appliance, protect the hob
with a piece of polystyrene from the packaging.
1.
Use a flat-blade screwdriver to push in the fastening
bolt, and turn it 90° until it locks into place.
¨
2.
Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing along
with the spring.
©
Pull gently on the fastening bolt; before you do this,
take hold of the appliance from beneath with the
other hand.
ª
3.
Carefully remove the appliance.
4.
Screw in the filler strip fully.
5.
Push in the fastening bolt and turn it 90°.
Note:
The fastening pieces on the left and right of
the appliance must be able to move.
Final fitting stage
1.
Slide the appliance up into place.
¨
2.
Lock the fastening bolts on the left and right.
©
3.
Fit the protective caps on the left and right.
ª
4.
Establish the electrical connection.
Note:
The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
■
The intermediate floor must not be placed on the
extractor hood's housing.
■
The front panel must not be secured to the housing.
■
Access must be available in order to change the
filter and for the after-sales service.
$
%
&
PP
[
%
$
&
