FLEXIDOME 5000 AN
Connection and set-up | en
23
Bosch Security Systems
Installation Manual
AM18-Q0648 | v1.0 | 2013.03
4.2.3
Focal length and focus
Before adjusting the focal length or focus, place the lens
adjustment cap on the lens to ensure that the image sharpness
is the same as when the dome is in place.
1.
Connect a monitor or other display device to either the
camera’s BNC connector or to the optional cable (S1460)
on the monitor jack. (If S1460 is connected, there is no
signal on the BNC connector.)
2.
Press and hold the menu/select (center) button until the
Install
menu appears.
–
The
Set focus
item is highlighted. Do not change this
selection as the camera is now in a special mode for
adjusting focus.
3.
To set the field of view of the varifocal lens, loosen the
focal length screw and turn the mechanism until the
required view is displayed on the monitor. (Image goes out
of focus.)
4.
Focus the image on the monitor by loosening the focus
screw and turning the mechanism until the image is in
focus.
5.
Re-adjust the focal length if necessary.
6.
Repeat these two adjustments until the desired view is in
focus.
7.
Tighten both screws.
8.
Use the navigation buttons to move to
Exit
and press the
center button until the menu disappears.
9.
Remove the lens adjustment cap from the lens and
disconnect the monitor.
4.2.4
Heater
When using the camera at low temperatures, set the heater
setting to
Auto
in the
Install
menu. The heater turns on at
ambient temperatures below 0°C (+32°F).
Summary of Contents for DIVAR AN 5000
Page 1: ...FLEXIDOME 5000 AN VDN 5085 en Installation Manual ...
Page 2: ......
Page 55: ......
Page 56: ...Bosch Security Systems www boschsecurity com Bosch Security Systems 2013 ...
