14
en | Configuration through the Web Interface
DSDA Digital Storage Disk Arrays
- | V2 | 2009.11
Installation Guide
Bosch Sicherheitssysteme GmbH
7.
Click
Modify
next to the network interface labeled
e0a
and configured with IP address
10.10.10.10.
8.
Enter the IP address information for the network. Change
IP Address
and
Netmask
to
the desired value. Leave
Broadcast
blank.
Example screen:
9.
Set
Media Type
to
10/100/1000 Mbit Auto-negotiate
.
Leave the
Trusted
option enabled.
10. Click
Apply
to confirm the changes. As this reconfigures the network interface you are
connected to, the page will fail to load after clicking the
Apply
button.
11. Reset the network settings of your computer to its original settings or settings suitable
for your CCTV network.
12. Reconnect to the FilerView interface using the new IP address of the storage system.
Enter
http://<newIPaddress>/na_admin
and log in using
root
as the user name and
leaving the password blank.
13. On the FilerView start page click the
FilerView
icon to open the administration interface
again.
6.2
Time and Date Settings
1.
In the navigation panel, select
Filer
>
Set Date/Time
.
The current date and time are displayed. If the time settings are incorrect, click
Modify
Date/Time
. This starts the
Date/Time Wizard
. While the wizard guides you through the
set-up, click
Next
to go to the next step. Click
Cancel
, if you do not want to continue the
procedure.
2.
From the list, select the
System Time Zone
. Click
Next
.
3.
Set
System Time Update Method
to
Manual
. Click
Next
.
4.
Enter the current time and date. Click
Next
.
Summary of Contents for DSA-N2B40
Page 1: ...DSDA Digital Storage Disk Arrays DSA N2B20 DSA N2B40 DSA N2B50 en Installation Guide ...
Page 2: ......
Page 37: ......
