P AG E 1 O F 1
Security Systems
Addendum Installation and Operation manual DVR600 Series
Support third party hard disks
From firmware version 2.0.6 onwards the DVR630/650 and 670 Series supports the use of unsigned hard disk
drives, allowing the use of third-party (non-Bosch) hard drives in the recorder.
The hard drives listed below are released and recommended for use in the DVR 600 Series Advantage Line
Digital Recorders. These are available from Bosch Security Systems as DVR-XSxx0-A Storage Expansion Kits.
We do not test drives other than those indicated above to verify reliability.
Warranty and support issues:
•
Bosch can not be held liable for any loss or damages or system malfunction resulting from the use of non-
Bosch drives in DVR 630/650 and 670 Series Advantage Line recorders
•
Bosch provides advance exchange and carry-in service on Bosch products only. Non-Bosch hard drives
should be removed from DVR 630/650 and 670 Series recorders when returning these units for repair.
•
Should non-Bosch hard disk drives be returned, then Bosch will not be held responsible for loss of these
drives or any information recorded on these drives or for any consequential damages.
•
Bosch will not be held liable for loss or consequential damages resulting from disclosure of any information
stored on non-Bosch drives.
Legal note:
Video loss is inherent to digital video recording; therefore Bosch cannot be held liable for any damage that results
from missing video information. Bosch does not make any commitments or promises regarding quality,
performance or other features with respect to third party hard disk drives. The information included here is
provided "as is".
No representation or warranty, express or implied, is or will be made in relation to, and no responsibility or liability is
or will be accepted by Bosch or its subsidiaries as to the accuracy or completeness of the given Information
included here or any other written or oral information made available to any.
© Bosch Security Systems, 2012
Version 1.1 2012.12
Doc. No.: AR18-12-B023
Subject to change
