Imp
ort
Ap
plia
nce
s.c
om
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Operating the appliance
en
9
Fan run-on time
Switching on
Touch the
y
symbol.
The fan runs at fan setting 1.
The remaining minutes of the run-on time are shown in
the display.
After approx. 10 minutes, the fan switches off
automatically.
Note:
You can use the rotary selector to adjust the run-
on time (
‚
to
ŠŠ
minutes).
Switching off
Touch the
y
symbol.
This immediately stops the fan run-on. The appliance
switches to the fan setting that was previously set.
Decorative LED lighting
The decorative LED lighting can be switched on and off
independently of the fan.
Touch the
l
symbol.
Setting the brightness
Press and hold the
l
symbol until the required
brightness is reached.
Setting the colour
1.
Switch off the fan.
2.
Touch the
l
symbol.
3.
Use the control ring to select the colour you want.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
B
symbol.
Setting the brightness
Press and hold the
B
symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols flash once the
appliance has been switched off:
■
Metal grease filter:
E
■
Activated charcoal filter:
F
■
Metal grease filter and activated charcoal filter:
E
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
~
"Cleaning and maintenance" on page 13
The saturation displays can be reset while they are
flashing. To do this, touch the
E
or
F
symbol.
Switching over the display for the air circulation
mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
off.
■
Touch and hold the
:
symbol. Use the rotary
selector to change the display to 2. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
cannot be regenerated).
■
Touch and hold the
:
symbol. Use the rotary
selector to change the display to 3. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
can be regenerated).
■
Repeatedly touching and holding the
:
symbol and
changing the display to "1" switches the electronic
controller back to air extraction mode.
Audible signal
Switching on
Touch and hold the
#
and
y
symbols at the same
time for approximately three seconds when the fan is
switched off. As confirmation, an audible signal sounds
and
‚
is shown in the display.
Switching off
Touch and hold the
#
and
y
symbols at the same
time for approximately three seconds when the fan is
switched off. As confirmation,
‹
is shown in the display.
