Imp
ort
Ap
plia
nce
s.c
om
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Operating the appliance
en
7
Sensor control
In automatic mode, the PerfectAir sensor in the
extractor hood detects the intensity of the cooking and
roasting odours. Depending on the setting of the
PerfectAir sensor, the fan automatically switches itself to
another fan setting.
Possible sensor settings:
Default sensitivity setting:
‡
Lowest sensitivity setting:
‚
Highest sensitivity setting:
‚‹
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
1.
Touch and hold the
>
symbol when the fan is
switched off. The setting will be displayed.
2.
Use the control ring to select the setting you require.
3.
Take your finger off the
>
symbol.
Fan run-on time
Switching on
Touch the
y
symbol.
The fan runs at fan setting 1.
The remaining minutes of the run-on time are shown in
the display.
After approx. 10 minutes, the fan switches off
automatically.
Note:
You can use the rotary selector to adjust the run-
on time (
‚
to
ŠŠ
minutes).
Switching off
Touch the
y
symbol.
This immediately stops the fan run-on. The appliance
switches to the fan setting that was previously set.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the
B
symbol.
Setting the brightness
Press and hold the
B
symbol until the required
brightness is reached.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
■
Metal grease filters:
E
■
Activated charcoal filter:
F
■
Metal grease filters and activated charcoal filter:
E
and
F
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
~
"Cleaning and maintenance" on page 13
The saturation indicators can be reset while they are
flashing. To do this, touch the
#
symbol.
Switching over the display for the air circulation
mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
off.
■
Touch and hold the
:
symbol. Use the rotary
selector to change the display to 2. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
cannot be regenerated).
■
Touch and hold the
:
symbol. Use the rotary
selector to change the display to 3. Take your finger
off the
:
symbol. This switches the electronic
controller over to air recirculation mode (filters that
can be regenerated).
■
Repeatedly touching and holding the
:
symbol and
changing the display to "1" switches the electronic
controller back to air extraction mode.
Audible signal
Switching on
Touch and hold the
#
and
y
symbols at the same
time for approximately three seconds when the fan is
switched off. As confirmation, an audible signal sounds
and
‚
is shown in the display.
Switching off
Touch and hold the
#
and
y
symbols at the same
time for approximately three seconds when the fan is
switched off. As confirmation,
‹
is shown in the display.
