8
Removing metal grease filter
1.
Fold the filter cover upwards.
Notes
■
The opening angle of the filter cover is limited to
approx. 80°. Do not open the filter cover any wider, as this
may damage the hinges.
■
The filter cover locks in any desired position.
2.
Take out the 2 metal grease filters under the filter cover.
Fold the lock downwards, pull the metal grease filter forwards
at the lock and remove it from the holder.
Note:
Fat may accumulate in the bottom of the metal grease
filter. Hold the metal grease filter level to prevent fat from
dripping out.
3.
Take out the metal grease filter on the underside of the
appliance.
4.
Clean the metal grease filter.
5.
After removing the filters, clean the inside of the appliance.
6.
Clean the filter cover.
Cleaning the metal mesh grease filters
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
:
Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
Notes
■
Do not use any aggressive, acidic or alkaline cleaning
agents.
■
When cleaning the metal mesh grease filters, also clean the
holder for the metal mesh grease filters in the appliance
using a damp cloth.
■
The metal mesh grease filters can be cleaned in the
dishwasher or by hand.
By hand:
Note:
You can use a special grease solvent for stubborn dirt. It
can be ordered via the Online Shop.
■
Soak the metal mesh grease filters in a hot soapy solution.
■
Clean the filters with a brush and then rinse them thoroughly.
■
Leave the metal mesh grease filters to drain.
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has no effect
on the function of the metal mesh grease filters.
■
Do not clean heavily soiled metal mesh grease filters together
with utensils.
■
Place the metal mesh grease filters loosely in the dishwasher.
The metal mesh grease filters must not be wedged in.
Installing the metal mesh grease filter
1.
Insert the 2 metal grease filters under the filter cover with the
lock facing downwards.
Fold the lock downwards, fold the metal grease filters
inwards and engage the lock.
2.
Insert the metal grease filters on the underside of the
appliance.
3.
Close the filter cover.
4.
Press and hold the
H
button.
The saturation indicator is reset.
Changing the activated charcoal filter
(only in circulating-air mode)
In order to guarantee efficient odour filtration, the filter must be
serviced regularly.
The activated charcoal filters must be replaced at least every
4 months.
Notes
■
The activated charcoal filters are not included in the delivery.
The activated charcoal filters can be obtained from specialist
retailers, from our after-sales service or from the Online Shop.
■
The activated charcoal filters cannot be cleaned or
reactivated.
1.
Remove the metal grease filters.
2.
Turn the old activated charcoal filters and pull away from the
holder.
¨
3.
Push the new activated charcoal filters onto the holder and
turn.
©
4.
Install the metal grease filters.
5.
Reset the saturation indicator; see section
Saturation indicator
.
%
$
