General information
en
13
K
General information
General information
Checking the wall
■
The wall must be level, vertical and adequately load-
bearing.
■
The depth of the bore holes must be the same
length as the screws. The wall plugs must have a
secure grip.
■
The enclosed screws and wall plugs are suitable for
solid brickwork. Suitable fasteners must be used for
other structures (e.g. plasterboard, porous concrete,
poroton bricks).
■
The maximum weight of the extractor hood is
40 kg
.
Electrical connection
:
Warning
Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do
not kink or pinch the connecting cable during
installation.
The required connection information can be found on
the rating plate on the top of the appliance.
Length of the cable: approx. 1.30 m
This appliance complies with the EC interference
suppression regulations.
:
Warning
Risk of electric shock!
It must always be possible to disconnect the appliance
from the power supply. The appliance must only be
connected to a protective contact socket that has been
correctly installed. If the plug can no longer be reached
after installation, an energy-isolating device in the
phases must be provided in the permanent electrical
installation in accordance with the installation
regulations. The permanent electrical installation must
only be wired by a professional electrician. We
recommend installing a residual-current circuit breaker
(RCCB) in the appliance's power supply circuit.
5
Installation
Installation
Preparing the appliance
1.
Pull back the adhesive strip from the stainless steel
flap and open the stainless steel flap. Do not
completely pull the adhesive strip off from the
appliance.
2.
Remove the polystyrene foam and metal grease filter
from the appliance.
3.
Install the metal grease filter in the appliance.
To do this, refer to the section
metal mesh grease filter" on page 8
.
4.
Close and secure the stainless steel flap. Use the
adhesive strip to do this.
Note:
Secure the adhesive strip in such a way that the
stainless steel flap does not swing up.
Summary of Contents for DWK67BM60B
Page 1: ...en Instructions for installation and use Extractor hood ...
Page 17: ...6 ...
Page 18: ...6 ...
Page 19: ...6 ...
