Bosch DWK67BM60B, Instructions For Installation And Use Manual

en

    Installation

14

Preparing the installation

Caution!

Ensure that there are no electrical wires, gas pipes or 

water pipes in the area where holes are to be drilled.

If the extractor hood is to be operated in air extraction 

mode, a flue duct must be fitted. 
If the extractor hood is to be operated in air-recirculation 

mode, an optional accessory must be fitted. To do this, 

refer to the installation instructions provided. The flue 

duct does not need to be fitted for air-recirculation 

mode.

1.

Determine where the extractor hood should be 

positioned and lightly mark where the lower edge of 

the appliance should be on the wall. In doing so, 

determine where the middle should be based on the 

hob.

Note: 

We recommend fitting the extractor hood such 

that the lower edge of the glass screen is in line with 

the lower edges of the adjacent wall-hung cabinets. 

Ensure that the specified safety clearances from the 

hob are complied with.

2.

Place the template against the line drawn on the wall 

and fasten it in place. Mark where the screws should 

be inserted.

To fit the flue duct, the template must be cut along 

the marked cut line.

3.

Drill 8 mm diameter holes to a depth of 80 mm for 

fastening the appliance, remove the template and 

press in the wall plugs flush with the wall. 

Fitting with a flue duct

Fitting without a flue duct

]

[

•PP

[

•PP

\

PP

PP

PP

PP

PP

[

PP

[

PP

PP

PP

PP