Installation
en
15
Installation
Screw in the mounting supports for the extractor hood
until they are hand-tight, use a spirit level to level the
appliance and then screw the mounting supports in
fully.
Wall-mounting the appliance and levelling it
1.
When mounting the appliance, ensure that it
engages properly with the mounting supports.
2.
If required, the appliance can be moved to the right
or to the left.
3.
Firmly tighten the screws for the mounting supports.
Hold the bracket firmly when doing so.
¨
4.
If no duct is fitted, screw in the two locking screws
without the bracket.
©
5.
Completely remove the adhesive strip.
Connecting the pipes
If the extractor hood is to be operated in exhaust-air
mode, the pipes must be connected. If the extractor
hood is to be operated in air-recirculation mode, an
optional accessory must be fitted. To do this, refer to
the installation instructions provided.
Note:
If an aluminium pipe is being used, smooth the
connection area beforehand.
Exhaust air pipe, dia. 150 mm (recommended size)
Fit the exhaust air pipe directly to the air-pipe connector
and seal the joint.
Exhaust air pipe, dia. 120 mm
1.
Fit the reducing connector directly to the air-pipe
connector.
2.
Attach the exhaust air pipe to the reducing
connector.
3.
Use suitable means to seal both joints.
Attaching the flue duct
If the extractor hood is to be operated in exhaust-air
mode, a flue duct must be fitted.
The flue duct does not need to be fitted for air-
recirculation mode.
:
Warning
Risk of injury!
From sharp edges during installation. Always wear
protective gloves while installing the appliance.
:
Warning
Risk of electric shock!
Components inside the appliance may have sharp
edges. These may damage the connecting cable. Do
not kink or pinch the connecting cable during
installation.
1.
Separate the flue duct sections by removing the
adhesive tape.
2.
Remove the pieces of protective film from both flue
duct sections.
3.
Push one flue duct section into the other.
Notes
– To prevent scratches, lay paper over the edges of
the outer flue duct section to protect the surface.
– The slots of the inner flue duct section point
downwards.
4.
Place flue ducts sections on the appliance.
5.
Slide the inner flue duct section upwards, attach it to
the left and right sides of the retaining bracket, and
then slide it down to engage it.
¨
Summary of Contents for DWK67BM60B
Page 1: ...en Instructions for installation and use Extractor hood ...
Page 17: ...6 ...
Page 18: ...6 ...
Page 19: ...6 ...
