2:5
The cooktop must be removed to access the surface burner igniter
orifice holder assemblies, burner valves, spark module
and other
components. To remove the cooktop
begin by removing the burner caps
and surface burners as previously described.
Next
using a 1/4 inch socket wrench or nut driver
remove the screws
that secure each orifice holder assembly to the cooktop. The arrows in
!
hoto A at right indicate the screw locations for the left
front orifice holder
assembly. Remove all screws at all burner locations before attempting to
remove the cooktop.
After the screws are removed
insert a putty knife or similar tool between
the bottom edge of the cooktop and the manifold panel
$
shown in photo B. Push in on the putty knife to release the lock
clip that holds the cooktop down. The corner of the cooktop can be easily
lifted
when the clip is released. Repeat this step on the opposite side.
Photo C shows detail and location of the cooktop lock clip.
Cooktop Removal
Photo A
Photo B
Photo C
3 Inches
