2:8
Loosen the nut that secures the gas tube to the burner control valve
as seen in photo A. The orifice holder assembly and igniter can now be
removed from the range.
When replacing an orifice holder assembly
it is important to make sure
that the nut is properly tightened to prevent gas leaks.
The factory torque
specifications in inch/pounds for this fitting are:
Minimum 25 - Maximum 40
Photo A
Nut
If the range has previously been converted for use with LP (propane)
as
you must remove the LP orifice from the original assembly and
install it into the replacement orifice holder.
Surface Burner
&
ontrol Valves
To replace a surface burner control valve
remove the surface burners
and cooktop as described in the previous sections. Disconnect the
orifice holder assembly from the valve being replaced.
Remove the surface burner control valve knobs by pulling the knob
forward off the valve shaft (
!
hoto B).
Photo B
Pull to
Remove
C
$"
that the metal insert remains in the knob when it is removed.
If the insert stays on the shaft, retrieve it and reinstall it into the
knob
(
!
hoto C).
If the insert is left out of the knob it will be very loose on the shaft.
Photo
Insert