2:11
Surface Igniter Spark Module
To access the surface burner igniter spark module
remove the surface
burners and cooktop as described in the previous sections. The spark
module is mounted onto a bracket located on the left side
near the left
rear burner as seen in photo E
#
Photo E
To access the module
remove the two screws that fasten the bracket
to the left hand body side
then roll the bracket and spark module over
(
!
hoto F).
Photo F
The spark module can also be accessed without removing the bracket
by depressing the locking tabs that hold it onto the bracket.
When reinstalling the module
$"
that the red wire is connected
to terminal L and the white/neutral wire is connected to terminal N on the
module. The green wire should be attached to the terminal nearest the
red wire.
&
In some models
the green wire may not be present.
'