2:23
7. A
'-867,1*7+(%$.(%851(5$,56+877(5
The air shutter for the oven
3
burner may need adjustment, especially if the unit has
been converted for use with LP/Propane gas. The approximate flame length of
the oven burner is 1 inch (distinct inner, blue flame) (
ee
$
ig
22).
6#
To access the air shutter
move the storage drawer or warmer drawer
#
2#
Remove the oven bottom
!
by removing the screws at rear of oven bottom.
Lift up
he rear of oven bottom
!
and slide toward back of range to disengage
from front of oven front frame.
#
Remove burner baffle by removing nut located on top of baffle and two screws from
front edge of oven front frame. Lift baffle straight up and out of the oven.
9#
Set the oven to bake at 350°F and observe the flame. If the flame is yellow in color,
increase air shutter opening size. If the flame is a distinct blue color, but lifting away
from the burner
reduce the air shutter opening size.
#
Turn off oven and allow to cool before adjusting air shutter. To adjust, loosen lock-
screw (3), reposition air shutter (2), and tighten lock-screw (3) (
$
23). Retest
the burner by repeating step “
9
” above. When the burner flame is a distinct blue
color burning steady, the air shutter is adjusted correctly.
.
Replace burner baffle and oven bottom
!
.
Fig
XUH
22
8. A
'-867,1*7+(%52,/%851(5$,56+877(5
6#
Observe the flame to determine if the broiler burner flame is properly adjusted.
It should be steady with approximately 1" blue cones and no yellow or orange
flame tips (
$
22).
2#
If adjustment to the air shutter is necessary, locate the broiler burner air shutter
(
$
24), loosen shutter lock screw, and adjust to obtain optimum flame.
This will normally be completely open for LP/Propane gas. If the flame is yellow
in color, increase the air shutter opening size. If the flame is a distinct blue,
but lifting away from the burner, reduce the air shutter opening size. Tighten
the shutter set screw.
F ig
XUH
23
Fig
XUH
24
F ig
XUH
25
/$%(/,1*7+(5$1*($)7(5&219(56,215(48,5('
After completing the conversion steps for the regulator, surface and oven
burners, refer to the LP kit instructions for labeling requirements and
instructions.