-20-
7. Align other end of rubber cord with guide
sleeve. Repeat steps for 2nd rubber cord
(Fig. 21).
8. To ensure proper alignment of rubber cords,
guide sleeves must be properly installed.
See (Figure 22) for correct orientation.
9. Rubber cord must be properly installed. See
(Figure 23) for correct orientation. Any
twisting of the cord will impair performance.
10 Replace Driver Sub-Assembly. Holding
tool securely with one hand, use other hand
to grab both sides of the driver sub-
assembly and then push forward into tool
(Fig. 24).
11. NOTE: To properly install driver sub-
assembly, the driver blade and guide rails
will need to be repositioned into correct
placement (Fig. 25). See following steps
for more detail.
*Tip: Place tool on nose (firing position, battery
removed) for better view.
12 Align driver blade (A) by inserting blade tip
into blade shaft opening (B) (Fig. 26).
FIG. 21
FIG. 22
FIG. 23
FIG. 24
FIG. 26
FIG. 25
CORRECT
INCORRECT
B
BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 20
