20
| English
1 619 929 857 | (28.7.09)
Bosch Power Tools
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 10.07.2009
Assembly
f
Before any work on the machine itself, pull
the mains plug.
Auxiliary Handle
f
Operate your machine only with the auxilia-
ry handle 11.
Rotating the Auxiliary Handle (see figure A)
The auxiliary handle
11
can be set to any posi-
tion for a secure and low-fatigue working pos-
ture.
Turn the bottom part of the auxiliary handle
11
in counterclockwise direction and swivel the
auxiliary handle
11
to the desired position. Then
retighten the bottom part of the auxiliary handle
11
by turning in clockwise direction.
Adjusting the Drilling Depth (see figure B)
The required drilling depth
X
can be set with the
depth stop
10
.
Press the button for the depth stop adjustment
9
and insert the depth stop into the auxiliary
handle
11
.
The knurled surface of the depth stop
10
must
face upward.
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder
1
. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to
incorrect adjustment of the drilling depth.
Pull out the depth stop until the distance between
the tip of the drill bit and the tip of the depth stop
correspond with the desired drilling depth
X
.
Selecting Drill Chucks and Tools
For hammer drilling and chiselling (chiselling
only with MV 200 accessory), SDS-plus tools are
required that are inserted in the SDS-plus drill
chuck.
For drilling without impact in wood, metal, ce-
ramic and plastic as well as for screwdriving,
tools without SDS-plus are used (e.g., drills
with cylindrical shank). For these tools, a key-
less chuck or a key type drill chuck are required.
Changing the Key Type Drill Chuck
To work with tools without SDS-plus (e.g., drills
with cylindrical shank), a suitable drill chuck
must be mounted (key type drill chuck or key-
less chuck, accessories).
Mounting the Key Type Drill Chuck
(see figure C)
Screw the SDS-plus adapter shank
14
into a key
type drill chuck
13
. Secure the key type drill chuck
13
with the securing screw
12
.
Please observe
that the securing screw has a left-hand thread.
Inserting the Key Type Drill Chuck
(see figure C)
Clean the shank end of the adapter shank and
apply a light coat of grease.
Insert the key type drill chuck with the adapter
shank into the tool holder with a turning motion
until it automatically locks.
Check the locking effect by pulling the key type
drill chuck.
Removing the Key Type Drill Chuck
Push the locking sleeve
3
toward the rear and
pull out the key type drill chuck
13
.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-265-002.book Page 20 Tuesday, July 28, 2009 11:05 AM
