18
| English
F 016 L81 183 | (28.4.16)
Bosch Power Tools
Inverter Mode
Combined Mode
If you are unable to resolve the problem using the troubleshooting guide then please contact your dealer in the first instance.
These conditions may change if you are using Class I or Class II tools with the product: please contact an electrician or the dealer
for advice.
Problem
Possible Cause
Corrective Action
Product does not
operate
On/Off switch button not properly activated
Press down the product on/off switch button for
3 s
Temperature too high or too low
Product will not operate until temperature is within
limits (refer to specification), let product cool
down or warm up
Load plug is not inserted properly into the product
outlet socket
Insert load plug fully into the product outlet socket
Overload switch tripped off – socket outlet over-
loaded
Reduce load from the outlet sockets and reset the
overload switch.
If this activates in rain: dry out the outlet socket and
restart the product.
Product works but shuts down within 5 min – load
too high
Reduce load from the output sockets and reset the
overload switch
If two outlet sockets are loaded: connect one prod-
uct after the other in at least 3 minutes interval
Connected product in use has been damaged
Remove damaged product from the output socket
and reset the overload switch
Connected product cable faulty
Replace faulty product cable
The product is damaged
Replace product
Problem
Possible Cause
Corrective Action
Product does not
operate
Faulty mains power cable or plug
Replace mains power cable or blown fuse (UK 13 A
adapter)
Wrong mains power cable
Use the specified power cable
Product power cable not properly plugged
Insert mains plug fully into the mains input socket
Residual Current Device (RCD) or Miniature Circuit
Breaker (MCB) – tripped off
Reset the RCD or MCB
Remove any extension cable used and charge the
product using the wall socket
Supply voltage outside range
Check that the supply voltage is within
220 – 240 V
Temperature too high or too low
Product will not charge until temperature is within
limits (refer to specification), let product cool
down or warm up
Socket outlet overloaded
Reduce load from the outlet sockets and reset the
overload switch.
If this activates in rain: dry out the outlet socket and
restart the product.
Load plug is not inserted properly into the product
outlet socket
Insert load plug fully into the product outlet socket
Battery charge level too low
Plug in mains to charge the product.
The product is damaged
Replace product
Product charges
slowly
Socket outlet overloaded
Reduce load from the outlet socket (above 1000 W
load will slow down the charging rate)
OBJ_BUCH-2703-003.book Page 18 Thursday, April 28, 2016 11:24 AM
