12 | English
1 609 92A 3EV | (16.5.17)
Bosch Power Tools
The unit must not be operated by chil-
dren or juveniles. Children should be
supervised to ensure that they do not
play with the unit.
The unit may only be used by author-
ised persons who have received
training or have demonstrated their
ability to operate the unit.
Wear personal protective
equipment (PPE) e. g. safety
goggles, dust mask etc. to pro-
tect against water, particles and/or aer-
osols sprayed back from parts. Do not
inhale aerosols if self-priming from ex-
ternal sources. Such water can contain
disease-causing agents.
Do not use the appliance within the
range of persons unless they also
wear protective clothing.
Connecting to the mains
The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
The operating voltage is 230 V AC,
(for non-European countries 220 V or
240 V, as applicable).
This is a class
I
unit and may only be
connected to properly earthed power
sources.
The electric supply installation shall
be made by a qualified electrician and
comply with IEC 60364-1.
We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
Requirements for extension cords
and plugs
Warning: Inadequate extension cords
can be dangerous. The extension
cord must have an earth wire. Exten-
sion cord, plug and socket must be of
waterproof construction, protected
against splashed water and intended
for outdoor use. If in doubt, contact a
qualified electrician or the nearest
Bosch Service Centre.
The following wire dimensions are
recommended: Up to 20 m length,
2.5 mm
2
wire diameter, up to 50 m
length 4.0 mm
2
wire diameter.
If your plug is not suitable for your
socket outlets, it should be cut off
and an appropriate plug fitted in its
place by an authorized customer ser-
vice agent. In case of electric plug
with internal fuse, the replacement
plug should have the same fuse rat-
ings as the original plug. The severed
plug must be disposed of to avoid a
possible shock hazard and should
never be inserted into a mains socket
elsewhere.
Products sold in GB only: Your prod-
uct is fitted with an BS 1363/A ap-
proved electric plug with internal fuse
(ASTA approved to BS 1362).
Remove the plug from socket when-
ever the machine is left unattended
for any period.
Do not touch the plug or socket with
wet hands.
Do not pull plug while operating the
device.
OBJ_BUCH-2319-004.book Page 12 Tuesday, May 16, 2017 11:15 AM
