PRF IU template project
en
33
Note:
Deviations between your appli-
ance and the diagrams may differ
with regard to their features and size.
Control panel
You can use the control panel to con-
figure all functions of your appliance
and to obtain information about the
operating status.
→ Fig.
1
The temperature controller sets the
temperature.
2
switches the appliance on or off.
3
switches Super freezing on or off.
4
switches the warning signal off.
Features
The features of your appliance de-
pend on the model.
Accessories
Use original accessories. These have
been made especially for your appli-
ance.
The accessories for your appliance
depend on the model.
Freezer tray
You can store the ice packs or freeze
smaller quantities of food in the
freezer drawer, e.g. berries, pieces of
fruit, herbs and vegetables.
→ Fig.
Distribute the frozen food evenly in
the frozen food tray and allow to
freeze for approx. 10 to 12 hours.
Then place in a freezer bag or a
freezer box.
Ice pack
Use the ice pack for temporarily
keeping food cool, e.g. in a cool bag.
Tip:
If a power failure or malfunction
occurs, the ice pack can be used to
slow down the thawing process for
the stored frozen food.
Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
Use only drinking water to make ice
cubes.
1.
Fill the ice cube tray with drinking
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2.
To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
Switching on the appliance
1.
Press .
a
The appliance begins to cool.
2.
Switch off the warning tone using
.
a
goes out as soon as the set
temperature has been reached.
3.
"Set the required temperature."
→
Operating tips
¡
Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡
The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡
When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
