Faults – what to do?
en
33
3
Faults – what to do?
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the
fault yourself.
--------
Temperature differs greatly from the set value.
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance"
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Displays do not illuminate.
The mains plug has not been inserted properly.
Connect the mains plug.
The fuse has tripped.
Check the fuses.
The power has failed.
Check whether the power is on.
The display flashes and the warning signal sounds.
Press the
°C
button. The alarm is switched off.
Appliance door is open.
Close the appliance door.
Ventilation openings have been covered.
Clear the ventilation openings.
Large quantities of fresh food were placed into the
appliance.
Do not exceed maximum freezing capacity.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
Start the appliance self-test.
"Appliance self-test" on page 34
When the programme has ended, the appliance
switches over to normal operation.
Summary of Contents for GIV Series
Page 87: ... X h ...
Page 88: ... ...