28
| English
1 609 929 N80 | (6.2.08)
Bosch Power Tools
– Set the circular saw with the premounted
guide-rail adapter
32
on to the guide rail
29
.
– Adjust the desired cutting depth and the bev-
el angle. Observe the marks on the guide-rail
adapter
32
for preadjustment of the various
bevel angles; see figure F.
– Align the circular saw with guide-rail adapter
in such a manner that the teeth of the saw
blade
22
face against the rubber lip. The po-
sition of the saw blade
22
depends on the se-
lected cutting angle. Do not saw into the
guide rail.
– Tighten wing bolt
8
to lock the position of the
guide-rail adapter.
– Remove the circular saw with the premount-
ed guide-rail adapter
32
from the guide rail
29
.
– Align the guide rail
29
on the workpiece in
such a manner that the rubber lip lies exactly
alongside the cutting edge.
– Fasten the guide rail
29
with suitable clamp-
ing devices, e. g., screw clamps, on the work-
piece. Set the circular saw with the pre-
mounted guide-rail adapter
32
on to the
guide rail.
– Switch the machine on and guide it in the
cutting direction applying moderate and
steady feed.
Two guide rails can be connected to one with
use of the connection piece
30
. Clamping is car-
ried out with the four screws located in the con-
nection piece.
Maintenance and Service
Maintenance and Cleaning
f
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool.
There is danger
of injury when unintentionally actuating the
On/Off switch.
f
For safe and proper working, always keep
the machine and ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean. Remove dust and chips by
blowing out with compressed air or with a
brush.
Saw blades that are not coated can be protect-
ed against corrosion with a thin coat of acid-free
oil. Before use, the oil must be removed again,
otherwise the wood will become soiled.
Resin and glue residue on the saw blade produc-
es poor cuts. Therefore, clean the saw blade im-
mediately after use.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer As-
sistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer consultants answer your ques-
tions concerning best buy, application and ad-
justment of products and accessories.
0
°
1-45
°
OBJ_BUCH-668-001.book Page 28 Wednesday, February 6, 2008 10:15 AM
