18
| English
1 609 929 S02 | (17.3.09)
Bosch Power Tools
Product Features
The numbering of the product features shown
refers to the illustration of the measuring tool
on the graphic page.
1
Exit opening for laser beam
2
Pulse-function indicator
3
Pulse-function button
4
Operating mode button
5
Battery indicator
6
Tripod mount 1/4"
7
On/Off switch
8
Battery lid
9
Serial number
10
Laser warning label
11
Latch of battery lid
12
Alignment plate*
13
0° alignment aid on the alignment plate
14
90° alignment aid on the alignment plate
15
45° alignment aid on the alignment plate
16
Pin on the alignment plate
17
Protective pouch*
18
Case*
19
Laser viewing glasses*
20
Measurement plate with stand*
21
Laser receiver*
* The accessories illustrated or described are not
included as standard delivery.
Assembly
Inserting/Replacing the Battery
Use only alkali-manganese batteries.
To open the battery lid
8
, press the latch of the
battery lid
11
in the direction of the arrow and
remove the battery lid. Insert the supplied bat-
teries. When inserting, pay attention to the cor-
rect polarity according to the representation on
the inside of the battery compartment.
When the battery indication
5
flashes red, the
batteries must be replaced.
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
f
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the bat-
teries can corrode and discharge themselves.
Operation
Initial Operation
f
Protect the measuring tool against mois-
ture and direct sun irradiation.
f
Do not subject the measuring tool to ex-
treme temperatures or variations in tem-
perature.
As an example, do not leave it in
vehicles for longer periods. In case of large
variations in temperature, allow the measur-
ing tool to adjust to the ambient temperature
before putting it into operation. In case of
extreme temperatures or variations in tem-
perature, the accuracy of the measuring tool
can be impaired.
f
Avoid heavy impact or falling of the measur-
ing tool.
After heavy exterior impact on the
measuring tool, an accuracy check should
always be carried out before continuing to
work (see “Levelling Accuracy”).
f
Switch the measuring tool off during trans-
port.
When switching off, the levelling unit,
which can be damaged in case of intense
movement, is locked.
OBJ_BUCH-817-003.book Page 18 Tuesday, March 17, 2009 8:51 AM
