-25-
Working Advice
Marking
When the laser beam runs through the cen-
ter of the reception area 6a, its height can be
marked at the center mark 7a right and left
on the tool.
When marking, make sure to align the tool for
each laser beam, both vertically and horizon-
tally. If this is not done, then the marks will be
offset from the laser beam.
Attaching with the Magnet
(see figure H)
When a mounting bracket is not required, the
tool can be attached to steel parts via the top
side using the magnet mounts 5a.
Keep the laser receiver clean at all times.
Do not immerse the laser receiver into
water or other fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents or
solvents.
If the laser receiver should fail despite the
care taken in manufacturing and testing
procedures, repair should be carried out by
an authorized after-sales service center for
Bosch power tools.
In all correspondence and spare parts
orders, please always include the 10-digit
article number given on the type plate of
the laser receiver.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries
instead of disposing of waste.
The unit, accessories, packag-
ing & used batteries should
be sorted for environmentally
friendly recycling in accordance with the lat-
est regulations.
LR30 Maintenance and Service
GRL800_900_1000 10-18.indd 25
10/4/18 7:07 AM
