-35-
RC1 Features
RC1 Operation
RC1 Operating Modes
The numbering of the product features refers to the illustrations on the remote control graphics page 32.
1c Button for rotational operation and
selection of the rotation speed
2c Button for line operation and line length
selection
3c Shock-warning reset button
4c Button for “rotation in clockwise
direction”
5c Button for “rotation in
counterclockwise direction”
6c Operation indicator
7c Outlet opening for infra-red beam
8c Battery lid
9c Latch of battery lid
10c Serial number
Initial Operation
• Protect the remote control against
moisture and direct sunlight.
• Do not subject the remote control to
extreme temperatures or variations
in temperature. As an example, do not
leave it in vehicles for longer periods. In
case of large variations in temperature,
allow the remote control to adjust to the
ambient temperature before putting it into
operation.
The remote control remains ready for
operation as long as a battery with sufficient
voltage is inserted.
Set up the laser tool in such a manner that
the signals of the remote control directly
reach one of the reception lenses on
the laser tool (for this, see the operating
instructions of the laser tool). When the
remote control cannot be pointed directly
against a reception lens, the working range is
reduced. By reflecting the signal (e.g. against
walls), the working range can be improved,
even for indirect signals.
After pressing a button on the remote
control, the illuminated operation indicator 6c
indicates that a signal was sent out.
Switching the laser tool on/off with the
remote control is not possible.
For detailed information of the laser tool
functions, see the operating instructions of
the laser tool.
Rotational Operation
(150/300/600 min-1)
The function of the button for rotational
operation 1c on the remote control is
identical with that on the laser tool.
Each time after switching on, the laser tool
is in rotational operation mode with average
rotational speed.
To switch from line operation to rotational
operation, press the rotational operation
button 1c. Rotational operation starts with
average rotational speed.
To change the rotational speed, press the
rotational operation button 1c again until the
requested speed is reached.
Line Operation, Point Operation
(10°/25°/50°, 0°)
The function of the button for line operation
2c on the remote control is identical with that
on the laser tool.
To switch to line or point operation, press
the line operation button 2c. The laser tool
switches to line operation with the smallest
aperture angle.
To change the aperture angle, press the line
operation button 2c. The aperture angle is
increased in two steps; at the same time, the
rotational speed is increased with each step.
When pressing the line operation button 2c
a third time, the laser tool switches to point
operation after brief post-pulsation. Pressing
button 2c again takes you back to line
operation with the smallest aperture angle.
GRL800_900_1000 10-18.indd 35
10/4/18 7:07 AM
