-26-
off altogether. This setting is not saved when
the laser level is switched off.
Manual operation
The automatic leveling of the laser level can
be switched off (manual operation):
– in the horizontal position for both axes in-
dependently of each other,
– in the vertical position for the X-axis (the
Y-axis cannot be leveled in the vertical posi-
tion).
It is possible to set up the laser level at any
inclination in the manual operation mode. The
axes can also be tilted independently of each
other in a range of ±8.5% on the laser level. In
manual operating mode, the slope value of an
axis will not be shown on the display.
The status indicator (12) on the laser level will
light up red continuously if:
– at least one axis is set to manual operating
mode in the horizontal position,
– the X-axis is set to manual operating mode
in the vertical position.
The Y-axis status display (35) or the X-axis sta-
tus display (34) on the remote control light up
red continuously if the relevant axis is set to
manual operating mode.
Manual operation cannot be started via re-
mote control.
Manual operation in the horizontal position
To switch off automatic leveling,
press the manual operation but-
ton (13) until the required set-
tings combination for both axes is
achieved. In the illustrated example, automat-
ic leveling for the X-axis is switched off and
the Y-axis continues to be leveled.
To tilt an axis with automatic lev-
eling switched off, press the
slope button (14) while the menu
for manual operating mode is
displayed.
If automatic leveling is only switched off for
one axis, it will only be possible to change the
slope of that axis. When manually operating
both axes, it is possible to switch between the
axes by pressing the slope button (14) again.
The symbol for the axis whose slope can be
changed will flash.
Tilt the selected axis using the ▲ (4) or ▼ (3)
buttons until the required position is reached.
Manual operation in the vertical position.
To switch off automatic leveling
for the X-axis, press the manual
operation button (13) once. (The
Y-axis cannot be leveled when in
the vertical position.)
To tilt the X-axis without using au-
tomatic leveling, press the slope
button (14) while manual operat-
ing mode is indicated on the dis-
play. The symbol for the X-axis
will flash on the display.
Tilt the X-axis using the ▲ (4) or ▼ (3) buttons
until the required position is reached.
To rotate the Y-axis, press the
slope button (14) again while
manual operating mode menu is
displayed. The symbol for the Y-
axis will flash on the display.
Rotate the Y-axis using the ▲ (4) or ▼ (3) but-
tons until the required position is reached.
Functions
CenterFind mode
In CenterFind mode, the laser level automati-
cally attempts to align the laser beam to the
center line of the laser receiver by moving the
rotation head up and down. The laser beam
can be aligned to the X-axis or the Y-axis of
the laser level.
CenterFind mode is started at the laser re-
ceiver. For this, please read and observe the
operating instructions for the laser receiver.
During the search, the Center-
Find symbol for one or both axes
will appear on the display of the
laser level and the status indicator
(12) will flash red.
If the laser beam was able to be aligned to
the center line of the laser receiver, the Cen-
terFind mode will automatically finish and
the slope found will be indicated on the start
screen.
If the laser beam could not be
aligned with the center line of the
laser receiver, the rotation of the
laser beam is stopped and an er-
ror message appears in the dis-
play. Press any button to close the error mes-
sage. The corresponding axis is leveled in
again to 0 %.
GRL4000-90CHVG 10-21.indd 26
10/20/21 3:24 PM
