1 609 929 U15 | (8.12.09)
Bosch Power Tools
22
| English
f
Do not use this to pneumatic tool to fasten electrical
wiring.
It is not suitable for fastening electrical wiring,
can damage the insulation of electric cables and thus
lead to electric shock and danger of fire.
f
Never use oxygen or flammable gases as the energy
source for the pneumatic tool.
Flammable gases are
dangerous and can cause the pneumatic tool to ex-
plode.
f
Use appropriate detectors to determine if utility lines
are hidden in the work area or call the local utility
company for assistance.
Contact with electric lines
can lead to fire and electric shock. Damaging a gas line
can lead to explosion. Penetrating a water line causes
property damage or may cause an electric shock.
f
The pneumatic tool may only be connected to lines,
for which the maximal permissible pressure of the
pneumatic tool cannot be exceeded by more than
10 %; for higher pressures, a pressure control valve
(pressure reducer) with preceding pressure-limita-
tion valve in the compressed-air line must be in-
stalled.
Excessive pressure leads to abnormal opera-
tion or breakage of the pneumatic tool, which can lead
to injury.
Functional Description
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
Intended Use
The pneumatic tool is intended for connecting work in
roofing, encasing, battening, manufacturing wall and ceil-
ing elements, wood facades, pallets, wood fences, noise-
reduction walls and boxes.
Only the fasteners (nails, staples, etc.) specified in table
“Technical Data” may be used.
Product Features
The numbering of the product features refers to the illus-
tration of the pneumatic tool on the graphics page.
1
Workpiece protector
2
Discharge lock-off
3
Depth stop
4
Air outlet
5
Handle
6
Air connector
7
Magazine slider
8
Magazine
9
Selector switch for actuation system
10
Trigger
11
Outlet
12
Air-connection coupling
13
Supply-air hose
14
Nail strip*
15
Magazine lock
16
Lock pin
17
Driver blade
18
Magazine holder
19
Magazine retainer at shot duct
20
Magazine rail
21
Locking screw
22
Cover lid
23
Spring clip
24
Screwable eyelet for pneumatic tool suspension
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
OBJ_BUCH-1037-001.book Page 22 Tuesday, December 8, 2009 1:03 PM
