Installation instructions
en
31
Food
Accessories/cookware
Shelf pos-
ition
Type of
heating
Temperature in
°C
Cook-
ing time
in mins
Small cakes
Baking tray
3
140-150
1
25-35
Small cakes, 2 levels
Universal pan
+
Baking tray
3 + 1
140-150
1
25-40
Small cakes, 3 levels
Universal pan
+
Baking tray
5 + 3 + 1
140
1
30-40
Hot water sponge cake
Springform cake tin,
diameter 26 cm
2
160-170
2
25-35
Hot water sponge cake
Springform cake tin,
diameter 26 cm
2
160-170
30-35
Hot water sponge cake, 2 levels
Springform cake tin,
diameter 26 cm
3 + 1
150-160
2
35-50
1
Preheat the appliance for five minutes. Do not use the rapid heating function.
2
Preheat the appliance. Do not use the rapid heating function.
Recommended settings for grilling
Food
Accessories/cookware
Shelf pos-
ition
Type of
heating
Temperature in
°C/grill setting
Cook-
ing time
in mins
Toasting bread
Wire rack
5
3
1
0.5–1.5
1
Preheat the appliance for five minutes. Do not use the rapid heating function.
23 Installation instructions
Observe this information when installing the appliance.
23.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
Proceed in accordance with the installation
sheets for installing accessories.
¡
Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket .
Summary of Contents for HBG5575.0A
Page 35: ......
