Bosch HBJ538EB0M, Instruction Manual

en

    Time-setting options

16

Setting the timer

The timer runs alongside other settings. You can set it 

at any time, even if the appliance has been switched off. 

It has its own audible signal so that you can tell whether 

it is the timer or a cooking time that has elapsed.
The maximum time that can be set is 23 hours and 59 

minutes. Up to 10 minutes, the timer duration can be 

set in 30-second increments.Above 10 minutes, the 

time increments become longer the higher the value.
The timer duration will start at a different default value, 

depending on which button you touch first: 

5 minutes if you touch the 

A

 button and 10 minutes if 

you touch the 

@

 button.

1.

Touch the 

v

 button until the timer symbol 

t

 is 

underlined.

2.

Use the 

A

 or 

@

 button to set the timer duration.

After a few seconds, the timer duration will start to 

count down.

Tip: 

If the set timer duration is the duration for which 

you wish to cook your food, use the cooking time. The 

appliance will then switch off automatically when it has 

finished cooking.

The timer duration has elapsed

An audible signal will sound. The timer duration will be 

zero on the display.
Touch any button to switch off the timer.

Changing and cancelling

You can use the 

A

 or 

@

 button to change the timer 

duration at any time. After a few seconds, the change 

will be applied.
To cancel, use the 

A

 button to reset the timer duration 

all the way to zero. The timer is now switched off.

Checking time-setting options

If time-setting options have been set, the corresponding 

symbols are lit up on the display. The symbol for which 

the time is currently being displayed will be indicated.
To check the values for the different time-setting 

options, touch the 

v

 button repeatedly until the 

required symbol is indicated.

Setting the time

Once the appliance has been connected to the mains 

or following a power failure, the clock will flash on the 

display. Set the time.

The function selector must be set to the "Off" position.

1.

Use the 

A

 or 

@

 button to set the time.

The time will stop flashing.

2.

Confirm by pressing the 

v

 button.

The appliance will apply the time you have set.

Note: 

You can go to the basic settings to specify 

whether or not the time should be shown on the display. 

~

 "Basic settings" on page 17

Changing the time

You can change the time again when you need to, e.g. 

from summer to winter time.
To do this, when the appliance is switched off, touch the 

v

 button until the symbol for the time is underlined, 

and use the 

A

 or 

@

 button to change the time.