Bosch HGD745350Y, Instruction Manual

8

Moving the appliance by the gas line or door 

handle

Do not move the appliance while holding the gas line; the gas 

pipe could be damaged. There is a risk of a gas leak! Do not 

move the appliance while holding it by the door handle. The 

door hinges and door handle could be damaged.

Electrical connection

Caution!

■

Have the appliance set up by your after-sales service. A 16 A 

fuse is required for connection. The appliance is designed for 

operation at 220-240 V. 

■

If the electricity supply drops below 180 V, the electrical 

ignition system does not work.

■

Any damage arising from the appliance being connected 

incorrectly will invalidate the guarantee.

■

If the supply cord is damaged, it must be replaced by the 

manufacturer, its service agent or similarly qualified persons 

in order to avoid a hazard.

For the after-sales service
Caution!

■

The appliance must be connected in accordance with the 

data on the rating plate.

■

Only connect the appliance to an electrical connection that 

meets the applicable provisions. The socket must be easily 

accessible so that you can disconnect the appliance from the 

electricity supply if necessary.

■

Please ensure the availability of a multi-pin disconnecting 

system.

■

Never use extension cables or multiple plugs.

■

For safety reasons, this appliance must only be connected to 

an earthed connection. If the safety earth terminal does not 

comply with regulations, safety against electrical hazards is 

not guaranteed.

■

You must use a H 05 W-F type cable or equivalent for the 

appliance connection.

Levelling the cooker

Always place the cooker directly on the floor.

1.

Pull out the plinth drawer and lift it up and out. 

There are adjustable feet at the front and rear on the inside of 

the plinth.

2.

Use an Allen key to raise or lower the adjustable feet as 

necessary until the cooker is level (picture A).

3.

Push the plinth drawer back in (picture B).

Wall fixing

To prevent the cooker from tipping over, you must fix it to the 

wall using the enclosed bracket. Please observe the installation 

instructions for fixing the oven to the wall. 

Setting up the appliance

■

The appliance must be set up directly on the kitchen floor 

and in line with the specified dimensions. The appliance must 

not be set up on any other object.

■

The distance between the top edge of the oven and the 

bottom edge of the extractor hood must meet the 

requirements of the extractor hood manufacturer.

■

Ensure that the appliance is not moved again after set up. 

The distance from the high output burner or wok burner to 

the fronts of the adjacent units or the wall must be at least 50 

mm.

Measures to be noted during transport

Secure all mobile parts in and on the appliance using an 

adhesive tape that can be removed without leaving any traces. 

Push all accessories (e.g. baking tray) into the corresponding 

slots with cardboard at the edges, in order to avoid damaging 

the appliance. Place cardboard or similar between the front and 

rear side to prevent knocks against the inside of the glass door. 

Secure the door and, if available, the top cover to the appliance 

sides using adhesive tape.
Keep the original appliance packaging. Only transport the 

appliance in the original packaging. Observe the transport 

arrows on the packaging.

If the original packaging is no longer available

pack the appliance in protective packaging to guarantee 

sufficient protection against any transport damage.
Transport the appliance in an upright position. Do not hold the 

appliance by the door handle or the connections on the rear, as 

these could be damaged. Do not place any heavy objects on 

the appliance. 

%

$

0LQ