English 9
Inserting Racks
Flat Rack
The rack is designed with a stop so it will stop before
coming completely out of the oven and not tilt.
To insert the flat rack into the oven:
1. Grasp rack firmly on both sides.
2. Insert rack (see picture).
3. Tilt rack up (A) to allow the upwardly sloped rear of the
rack to slide under the stop molded into the front
portion of the rack guide above.
4. When the back of the rack is past this stop, lower the
front of the rack to a horizontal position (B) and push it
the rest of the way in.
The rack should be straight and flat, not crooked.
To remove the flat rack from the oven:
1. Grasp rack firmly on both sides and pull rack toward
you.
2. When the stop is reached, tilt rack up so that the
upwardly sloped back of the rack can pass under the
stop. Pull the rack the rest of the way out.
Telescopic Rack (some models)
To insert the telescopic rack into the oven:
1. Slide the rack in evenly until the rear of the rack is
about 2 inches from the back of the oven.
2. Tilt the front of the rack up about 3/4’s of an inch (A)
and finish pushing the rack all the way back (B)
Note:
Avoid striking the oven light cover glass when
pushing the rack into position.
3. The back of the telescopic rack drops into place.
4. Pull the rack forward to engage the bottom of the rack
onto the rear of the rack position guide.
5. Lower the front of the rack to finish seating it on the
rack guide. The rack should feel stable when properly
seated.
6. Slide the movable part of the telescopic rack in and out
a few times to make sure it is able to move freely and
that the non-moving part of the telescopic rack is
securely anchored.
To remove the telescopic rack from the oven:
1. Lift the front of the telescopic rack assembly about 1/2
inch and push the rack to the rear about 3/4 inch. This
allows the rack to disengage from the rack position
guide.
2. Lift the rear of the telescopic rack assembly so it clears
the rack position guide and gently pull the rack from the
oven.
9
CAUTION
To avoid burns, place oven racks in desired
positions before turning oven on. Always use oven
mitts when the oven is warm. If a rack must be
moved while the oven is hot, do not let oven mitts
contact hot heating elements.
Use caution when removing an oven rack from the
lowest rack position to avoid contact with the hot
oven door.
To avoid possible injury or damage to the appliance,
ensure racks are installed exactly per installation
instructions and not backwards or upside down.
9
CAUTION
To avoid possible injury or damage to the appliance,
ensure the telescopic rack is installed exactly per
installation instructions and not backwards or upside
down.
