Bosch HIS8055C, Installation Instructions Manual

Installation procedure

 en-us

9

2.7 Installation checklist

Please refer to the following pages for complete installa-

tion instructions. Use this checklist to verify that you have

completed each step of the installation process. This can

help you avoid mistakes.

Installation step
Before installing the range, be sure to verify the

cabinet dimensions are correct for your unit and

that the required electrical connections are

present.
Before installing the range, make sure that any

opening in the wall behind the appliance and in

the floor under the appliance shall be sealed.
Read this installation manual for content regard-

ing Safety, Cabinet Dimensions, Removing

Packaging, Electrical Installation and Customer

Service.
Removing the oven door prior to installation re-

duces the unit weight and makes the range eas-

ier to move. Additionally, the removal of the

oven door provides access to handholds for lift-

ing.
Install and adjust the feet.
Move the range (2 people needed) into place in

front of the installation opening, leaving the bot-

tom packaging on the unit to avoid damaging

flooring.
Plug the range into a properly configured recep-

tacle.
Protect the flooring from damage, then slide the

unit all the way into place, making sure to route

the power cord correctly.
Reinstall the oven door.
Make sure the anti-tip bracket is engaged.

Installation procedure

3 Installation procedure

Installation procedure

3.1 How to remove the oven door

WARNING

Failure to follow these instructions when removing the

oven door may lead to personal injury or product damage.

▶

Make sure oven is cool and power to the oven has been

turned off before removing the door. Failure to do so

could result in electrical shock or burns.

▶

The oven door is heavy and parts of it are fragile. Use

both hands to remove the oven door.

▶

The door front is glass. Handle it carefully to avoid

breakage.

▶

Grasp only the side of the oven door. Do not grasp the

handle. It may swing in your hand and cause damage or

injury. Failure to grasp the oven door firmly and properly

could result in personal injury or product damage.

▶

To avoid injury from hinge bracket snapping closed, be

sure both levers are securely in place before removing

the door.

▶

Do not force the door open or closed. The hinge could

be damaged and cause damage or injury.

▶

Do not lay the removed door on sharp or pointed ob-

jects as this could break the glass. Lay it on a flat,

smooth surface, positioned so that the door cannot fall

over.

Note: To avoid injury or damage, make sure that you read

the above WARNING before attempting to remove the

oven door.

1.

Open the oven door to its fully open position.

2.

Lock the two hinges on the left and right using the lock-

ing pin. The locking pins must be fully inserted into the

holes in the hinges.

3.

CAUTION Closing the door by 8" (203 mm) takes

the pressure off the spring. If this is not done, the door

can still be removed but the latch will now slam shut

and may pinch or cut your hand.
Close the oven door until it catches on the hinge stop

levers, locking the hinges at the correct angle for door

removal. The door can be removed when it is pulled up

from the open position by about 8 inches (203 mm).

This takes the tension off the spring-loaded hinges so

that the door can be easily lifted out.

4.

The door is heavy. Use both hands to firmly grip it by

the sides. Do not grip the door by the handle. Keeping

the angle of the door the same, lift the door straight up

approximately 3/4" (19 mm) to unhook the hinges from

the slots. Pull the door out towards you until the hinges

are clear of the oven housing.

5.

Place the door in a convenient and stable location for

cleaning.