Bosch HSG734357Z, Instruction Manual

Causes of damage       

en

7

:

Warning – Burn-Back (Fire in burner tube 

or chamber)! 

In the event of a burn-back, where the flame 

burns back to the jet, immediately turn off the 

gas supply at the control valve on the panel. 

After ensuring the flame is extinguished, re-

light the appliance in the normal manner. 

Should the appliance again burn back, close 

the control valve and call a service technician. 

Do not use the appliance again until the 

service technician has declared that it is safe 

to do so.

:

Warning – Gas-pressure regulator! 

This appliance requires an operating pressure 

of 2,8

kPa at the appliance. A suitable LPG 

regulator that complies with the requirements 

of SANS 1237

must be installed.

:

Warning – Important Information for the 

user! 

This appliance may only be installed by a 

registered LP Gas installer. All registered 

installers are issued with a card carrying their 

registration number. Ask to be shown the card 

before allowing the installation work to 

commence and make a note of the Installer 

QCC number. Upon completion of the 

installation, the installer is required to explain 

the operational details of the appliance 

together with the safety instructions. You will 

be asked to sign acceptance of the installation 

and be provided with a completion certificate. 

You should only sign for acceptance of the 

installation when the installation is completed 

to your satisfaction. 

Note that your invoice is required in the event 

that you wish make a guarantee claim.

:

Warning – Important Information for the 

installer! 

This appliance may only be installed by a LP 

gas installer registered with the Liquefied 

Petroleum Gas Association of Southern Africa. 

The appliance must be installed in accordance 

with the requirements of SANS 10087-1

and 

any fire department regulations and/or local 

bylaws applicable to the area. If in doubt 

check with the relevant authority before 

undertaking the installation. Upon completion 

of the installation you are required to fully 

explain and demonstrate to the user the 

operational details and safety practices 

applicable to the appliance and the 

installation.

]

Causes of damage

Causes of damage

Hob

Caution!

■

Only use the burners when cookware has been 

placed on top. Do not heat up empty pots or pans. 

The saucepan base will be damaged.

■

Clear up spills immediately. Use deep pots for 

dishes with a lot of liquid. This will prevent the food 

from boiling over.

■

Do not use roasting dishes if they must be heated 

using two burners. This will cause heat 

accumulation. The appliance could be damaged.

■

Cooking on gas burners releases extra heat and 

moisture. Adjacent units may become damaged over 

time. For long cooking times, switch on the cooker 

hood or ventilate the room.

■

Observe the manufacturer's instructions when using 

special ovenware.Aluminium foil and plastic 

containers can melt and stick on hot burners.

■

Place the pot or pan centrally over the burner. This 

will optimise transfer of the heat from the burner 

flame to the pot or ban base. The handle does not 

become damaged, and greater energy savings are 

guaranteed.

■

Ensure that the gas burners are clean and dry. The 

burner cup and burner cap must be positioned 

exactly.

■

Ensure that the hotplate/burner is never switched on 

when the hob cover is on, e.g. by children playing.