19
BOSCH
ENGLISH
* Model dependent
You may continue ironing for a time. Once this time
has passed, you will only be able to dry iron (without
steam).
To start steam ironing again, follow this descaling
process:
1
Fill the tank (7) with water.
2
Plug in the mains cable (5) and press the button (2) to
switch the appliance on.
3
Press the descaling button (1) for 2 seconds. Its
indicator light will remain permanently lit.
4
Wait until the indicator light (2) stops flashing and
remains lit permanently. Two beeps will be heard.
5
Place the iron on the "Calc'nClean" container (14).
Make sure that the surface on which the container is
placed is stable.
Warnings:
• Do not remove the iron from the container until the
process has finished.
Boiling water and steam will be released through
the soleplate, removing limescale and/or deposits
that may be inside.
• The container must only be used to perform the
descaling process. It must not be used as a stand
for the iron while ironing.
6
Press the steam release button (12) for 2 seconds.
The descaling process will start automatically. During
this process, short beeps will be heard.
7
After approximately 3 minutes, the iron will stop
releasing steam. A long beep will be heard, indicating
that descaling process has finished. The appliance
will switch off automatically.
8
To clean the soleplate (13), immediately rub off any
residue by running the hot iron over a wet cotton cloth.
Wipe the housing of the iron with a cloth.
Warning: The container gets hot during the descaling
process.
9
Let it cool down and then empty the container.
2”
2x
