Troubleshooting
en
13
▶
Remove the batteries if you are not using the re-
mote control.
▶
Safely dispose of empty or defective batteries in an
environmentally friendly manner.
1.
Remove the cover.
2.
Remove the empty batteries.
3.
Insert the new batteries (3 V CR 2032).
4.
Close the cover.
5.
Dispose of the empty batteries in an environmentally
friendly manner.
11 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced by trained specialist staff.
11.1 Malfunctions
Fault
Cause and troubleshooting
The appliance is not working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
The lighting does not work.
Different causes are possible.
▶
Call the after-sales service.
▶
Defective LED lights may be replaced by the manufacturer, their customer
service or a qualified technician (electrician) only.
Remote control not working.
The batteries are flat.
▶
"Replacing the batteries in the remote control", Page 12
In the LED display, the LEDs
flash one to five times after the
appliance is switched off.
The batteries are almost empty.
▶
"Replacing the batteries in the remote control", Page 12
LED 1 flashes in the LED display. The grease filters are saturated.
▶
"Cleaning grease filters in the dishwasher", Page 12
▶
"Cleaning grease filters manually", Page 12
LED 2 flashes in the LED display. The odour filters are saturated.
▶
Change the odour filter.
HomeConnect is not working cor-
rectly.
Different causes are possible.
▶
Go to www.home-connect.com.
