Bosch IntuiKey, User Manual

16

en | Controlling Allegiant Series Video Switchers

IntuiKey Keyboard

F.01U.080.637 | 1.92 | 2008.12

User Manual

Bosch Security System, Inc.

2.4

Allegiant Error Messages

Error

Name

Description

Error 01

Invalid Camera Request

The camera number entered from the keyboard does not exist. If 

using the optional LTC 8059/00 Master Control Software or the LTC 

8850/00 Graphical User Interface Software, ensure that the number 

exists in the Camera Identification table. Download the table to be 

sure.

Error 02

Invalid Monitor Request

The monitor number entered from the keyboard does not exist.

Error 03

Remote Device Locked by User#

The remote device requested cannot be controlled, because it is 

locked by a user with equal or higher priority. Check with the other 

users or request that a higher priority user unlock the remote 

device.

Error 04

Monitor Locked by User#

The monitor requested cannot be accessed, because it is locked by 

a user with equal or higher priority. Check with the other users or 

request that a higher priority user unlock the monitor. 

Error 05

Remote Device Access Restricted

Remote locked out by Remote Lock Out table.

Error 06

Monitor Access Restricted

Monitor locked out by Monitor Lock Out table.

Error 10

Access Denied

A function was requested for which the user priority is too low. Only 

a Priority 2 user or a supervisor with Priority 1 may access this 

function.

Error 11

Access Denied

A function was requested for which the user priority is too low. Only 

a supervisor with Priority 1 may access this function. 

Error 15

Invalid User Function

The function number requested from the keyboard is invalid. Refer 

to the User Function table for a listing of valid user function 

numbers.

Error 20

Acknowledge Denied

The ACKNOWLEDGE button was pressed by a user without the 

authority to acknowledge alarms.

Error 21

Incorrect Acknowledge

In order to properly acknowledge an alarm event, the keyboard 

must be switched to a monitor that is displaying the alarms.

Error 22

Acknowledge Disabled

Alarms on this monitor cannot be acknowledged, because that 

capability has been disabled by the system programmer.

Error 23

Camera not in Alarm

The camera displayed on the monitor is not an alarm video; only 

alarm-generated video can be acknowledged.

Error 24

Keyboard Not Enabled for 

Acknowledge

This keyboard may not acknowledge alarm video on this monitor; it 

has been disabled by the system programmer. 

Error 25

Alarm Switcher Running

Alarm video may only be acknowledged if the alarm switcher is not 

running; press HOLD to stop the switcher.

Error 50

Sequence Not Available

The user attempted to load a switcher sequence that does not exist. 

This is a good way to determine, from the keyboard, which 

sequence numbers are unused when desiring to add one. A request 

was made to load an ABSOLUTE type sequence, without the 

keyboard being on one of the monitors in that sequence. Because 

inadvertent loading of monitors should be avoided, the user is 

required to switch his keyboard to one of the monitors used by the 

sequence. The PROGRAM mode may be used to review which 

monitors are used in the sequence.

Error 52

Sequence Request

A request was made to load a RELATIVE type sequence on a monitor 

number that is too high; the monitors used by the sequence would 

extend past the highest monitor. Try switching to a lower monitor 

number before loading the sequence.