Installation
en
19
Fitting the appliance
1.
Hook the appliance from below into the support
frame.
Note:
Ensure that the mains cable is not trapped.
2.
Fasten the appliance to the support frame using 2
securing screws.
3.
Hook in the retaining clip and screw tight.
Connecting the pipes
Note:
If using an aluminium pipe, smooth the
connection area beforehand.
Exhaust-air pipe Ø 150 mm (recommended size)
Attach the exhaust-air pipe directly to the air-pipe
connector and seal.
Exhaust-air pipe Ø 120 mm
1.
Attach the reducing connector directly to the air-pipe
connector.
2.
Attach the exhaust air pipe to the reducing
connector.
3.
Seal both joints appropriately.
Attaching the flue duct
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
1.
Separate the flue ducts.
To do this, remove the adhesive tape.
2.
Remove the protective foil from both sides.
3.
Place both parts of the upper flue on the appliance
and push together.
Note:
The slots of the upper flue must point
downwards.
4.
Push up the upper flue part and secure with 2
screws.
5.
Insert both lower parts of the flue and push together.
[
[
Summary of Contents for iQ700 LF91BUV50B
Page 1: ...Extractor hood en Instructions for installation and use ...
Page 2: ......
