3.
Mount the speaker.
4.
Plug the Euroblock connector into the speaker.
5.
Readjust the horizontal or vertical speaker position.
Wiring the speaker using the Euroblock connector and weather cover – optional accessory
To wire the speaker using Euroblock connector and weather cover, do the following:
1.
Push the wire through the gland nut.
2.
Wire the Euroblock connector (A).
A
B
C
3.
Adjust the tap settings, if needed.
4.
Mount the speaker.
5.
Plug the Euroblock connector into the speaker.
6.
Insert the screws into the weather cover (B).
Loosely tighten the four screws to keep the weather cover in place.
7.
Tighten all four screws to secure the weather cover.
Ensure the weather cover is secure.
8.
Adjust the wire length.
9.
Tighten the gland nut (C).
10. Readjust the horizontal or vertical speaker position.
See also
–
Installing the speaker, page 10
Transformer taps
You can select the mode of operation for all models that have a transformer. For the LB20-
PC15-4 you can select the power tap for 70V/100V operation by using the jumper connector in
the Euroblock on the input panel. For the LB20-PC30-5 and the LB20-PC60-8 you can select
the mode of operation (70V/100V/8 ohm) and power taps using the rotary switch on the input
panel.
4.3
Premium Cabinet Loudspeakers
Installation and wiring | en
15
Bosch Security Systems B.V.
Installation manual
2017.08 | 01 | F.01U.345.357
Summary of Contents for LB20-PC15-4
Page 1: ...Premium Cabinet Loudspeakers en Installation manual ...
Page 2: ......
