LE10 Radio Receiver
Operation | en
45
Bosch Security Systems
User Manual
F.01U.139.675 | V1.3 | 2013.05
If, during these 10 seconds, no S37E transmitter is detected:
–
LED 2 lights up red for 2 seconds.
–
Relay 1 switches on for 2 seconds.
–
Relay 2 stays off.
6.5
Remote control (mode 5)
6.5.1
Activation of a programmed transmitter
Device behavior
–
LED 1 stays permanently green.
–
LED 2 lights up red.
–
Relay 1 switches on.
–
Relay 2 stays off.
When the same transmitter is activated again:
–
LED 2 turns off.
–
Relay 1 switches off.
6.5.2
Activation of a programmed transmitter with a
battery-low message or with a new battery
The behavior of the device is the same as in
Section 6.2.1 Activation of a transmitter in normal mode, page 42
.
6.6
Open receiver (modes 6 and 7)
6.6.1
Activation of a transmitter in the reception range
Device behavior
–
LED 1 stays permanently green.
–
LED 2 lights up red for 10 seconds.
–
Relay 1 switches on for 10 seconds.
NOTICE!
In mode 4, there is no battery-low indication.
NOTICE!
No other transmitter is able to switch the Relay 1 off, when it
has been already switched on by a transmitter.
